Many people don’t know how to configure the host IP of the Cisco simulator? The article brought to you today is about how to configure the host IP of the Cisco simulator. If you still don’t know, let’s learn it with the editor.

Step 1: First, we open the Cisco Simulator (Cisco Packet Tracer) software on the computer and wait for it to run (as shown in the picture).

Step 2: Then we find the menu button of our host class and click to open it (as shown in the picture).

Step 3: Then we find the host type we need, press and drag it to the blank interface and place it (as shown in the picture).

Step 4: Then we click on the host once to open the control interface, then find Desktop and click to open (as shown in the picture).

Step 5: Find the IP configuration location (as shown in the figure).

Step 6: Then we fill in the IP address, default gateway and other contents, and then close it directly. In this way, we have successfully configured the host IP (as shown in the figure).

The above is the entire content of how to configure the host IP of the Cisco emulator brought to you by the editor. I hope it can help you.