What are the common problems with the HP LaserJet M1005 MFP driver? This chapter mainly introduces the HP LaserJet M1005 Answers to frequently asked questions about MFP drivers. For those who don’t know yet, please follow the editor to learn. I hope it will be helpful to you.

​ 1. Why can’t the HP LaserJet M1005 MFP printer driver detect the hardware and install the driver?

​ ​ 1. The printer data cable is too long, if it exceeds 3 meters, the computer will not be able to detect the printer.

​​ 2. There is something wrong with the quality of the data cable connected to the printer. Replace it with a new one and test it.

​​ 3. If the computer USB is damaged, replace it with another USB interface for testing. Do not use the USB port on the front of the computer.

4. If there is a problem with the computer system, reinstall the computer system or change to another computer for testing.

5. If there is a problem with the computer system, reinstall the computer system or change to another computer for testing.

​ ​ 2. The HP LaserJet M1005 MFP printer driver displays a yellow exclamation mark in the device manager. When updating the driver and prompting to install the device, an error occurs and the data is invalid?

​​ 1. Right-click the HP LaserJet M1005 MFP driver printer exclamation mark device in the device manager and update the driver.

​​ 2. If the update cannot be performed normally and the exclamation mark still appears, check whether the USB cable length is within 2 meters. Replace other USB interfaces on the computer and connect the USB cables one by one to see if the device can be detected in the device manager.

3. Replace the data cable with better communication or use another computer to reinstall the driver and test it.

3. HP LaserJet M1005 MFP printer driver installation failed?

​​ 1. Unzip the HP LaserJet M1005 MFP driver you downloaded into a folder

2. Start - Settings - Printers and Faxes - Add Printer - Next - Uncheck the Automatically detect and install plug-and-play printer (A) - Next - Next - Install from Disk ——Browse--Find the drive letter where the printer driver is located--Double-click the file with the gear--Select 1005--Next step--Select Yes for the default printer--Next step--Do not print a test page--Finish

3. Connect the printer to the computer and turn on the printer.

​ 4. Start - Settings - Printers and Faxes - The 1005 driver icon has already appeared. Right-click and select Properties - Port - the default is LPT1 - pull down - see the USB port selection - OK

5. Right-click My Computer - Manage - Services and Applications - Services - Find Print Spooler - Restart

​​ 6. Driver installation completed

The above is all the frequently asked questions about the HP LaserJet M1005 MFP driver. I hope it can be helpful to everyone!