How to install the system using ghost? How to install the system using ghost

How to install the system using ghost? This chapter mainly introduces the steps of installing the system using ghost. If you don’t know yet, please follow the editor to learn. I hope it will be helpful to you.

​ ​ 1. Start our ghost tool. After starting, you can see the following interface, click OK to enter.

​ ​ 2. Then we will see the following interface. At this time, click and select as shown in the picture below. Since we want to install the system, we will select the third item according to the picture.

3. Then find the location of the system image folder and click Browse to select it.

​​ 4. After confirming the image, you will see the following interface, and then select the target hard disk. Generally, computers only have one, so this is a good choice.

5. Next, when selecting the target partition, you also need to decide which drive the system will be installed on. Usually, you choose the C drive.

​​ 6. After setting according to the above selection, a dialog box will pop up, click YES and wait for the system to be installed.

      以上这里为各位分享了使用ghost安装系统方法。 Friends in need, please come and read this article!