There may be many friends who still don’t know where the multisim14.0 grounding is? Then those who don’t know can take a look at the introduction of the multisim14.0 grounding location brought by the editor. I hope it will be helpful to all my friends.

Ground symbol: source--》POWER_SOURCE --》GROUND

1. In the power options: Ground in the sources library

2. Or find the power supply in the added components. The GND inside is the ground and connect it with a wire.

3. Grounding is done by right-clicking in the toolbar

Select Components in the pop-up dialog box;

Click on the first icon in the toolbar that appears;

In the Group in the Select a components dialog box that pops up;

Then select the sources component;

You can find it by selecting Ground in the last column next to it.

You can try them both, but there are several differences you need to distinguish:

power ground

signal ground(signal ground)

earth(earth)

Right-click - place component - and select sources.

Then click power_sources and select GROUND. in the right box.

The following are commonly used ground symbols:

The general symbol for grounding: one vertical and three horizontal, with the vertical connected to the first horizontal. Noiseless grounding: General grounding with a half-round port facing downwards. Protective grounding: On the basis of general grounding, add a circle to cover the lower three horizontal lines.

The above is the introduction of multisim14.0 grounding location brought by the editor. Friends in need should not miss it.