How to use Driver President - How to use Driver President to set the system preinstallation mode

How to use the driver to set the system pre-installation mode? Some friends may not know yet, so today I will bring you the method of using the driver to set the system pre-installation mode. Friends who don’t know yet come and learn it quickly. I hope it can help you.

The first step is to open the main interface of the driver president

The second step is to click on the three bars

The third step is to click on the multi-system pre-installation mode

Step 4: Click to enter multi-system pre-installation mode

Step 5: Select the system preinstalled disk

Step 6: Click to load the driver to the target system.

The above is the method shared by the editor to use the driver to set the system pre-installation mode. Friends in need should not miss it.