Do you know how to use chamfering in AutoCAD2017? Some friends may not know it yet, so now the editor has brought you an introduction to chamfering skills in AutoCAD2017. Friends in need can come and take a look. I hope it can help you.

When drawing a rectangle, you can directly set the rounded corners of the rectangle. Enter REC in the command line, followed by a space and enter F to directly set the radius of the rounded corners.

But in this setting, the four corners of the rectangle are set to the same radius size at the same time.

If we only want to chamfer one corner of the rectangle, enter the F space, and after entering the radius, click directly on both sides of the rectangle.

This can achieve the effect we want.

Next, we round two straight lines. As shown in the figure, we look at two inclined straight lines. As shown in the figure, we chamfer two non-parallel straight lines

We can also use the F command to achieve such a rounding effect. Enter the chamfer radius on the command line.

At this time we will get the effect as shown in the picture. Remember that if the chamfer is too large, it will not be successful.

What needs to be noted here is that if there are two parallel lines, we can set the radius of the chamfer to 0 to quickly connect the arcs.

The above is the introduction of AutoCAD2017 chamfering skills brought by the editor. Friends who don’t know it yet remember to learn it.