How to use the Canon MP288 reset software? Some friends may not know it yet, so today I will share with you how to use the Canon MP288 reset software. Friends in need can come and take a look. I hope it can be used. Help everyone.

First turn off the power of the printer, load 3 sheets of A4 copy paper into the printer, and then prepare the printer to enter maintenance status:

1. First press and hold the Stop/Reset button, then press the <Power> button to turn on the phone (do not release it).

2. Press the <Power> button, and without letting go, release the <Stop/Reset> button (the power button is still pressed and held at this time).

3. Then press the <Stop/Reset> button 5 times, and hold it down when pressing the last time. (At this time, both the <Power> button and the <Stop/Reset> button are pressed and held).

4. Release the <Power> button and the <Stop/Reset> button at the same time. After the printer is started and running, the printer will display "0", which means it enters the printer maintenance mode.

5. The computer prompts to find new hardware and prompts to install the driver. Leave it alone. If the new hardware is not found, it is recommended to restart the computer or try changing the computer.

The above is the method of using the Canon MP288 clearing software shared by the editor. Friends who don’t know how to do it should hurry up and learn it.