Don’t you know how to use Canon mp288 clearing software to clear the printer? Then friends who don’t know how to do it, come and learn how to clear the Canon mp288 clearing software with the editor. I hope that by studying this tutorial, you can Help all my friends.

The first step is to put the printer into maintenance mode.

1. Make sure the printer power switch is turned off, first press the [Cancel/Stop] key, and then press the [Power Switch] key. (Do not release either button.)

2. When the power light lights green, do not release the [Power Switch] button at the same time, release the [Cancel/Stop] button, then press the [Cancel/Stop] button 5 times, and then release the [Power Switch] at the same time. [Cancel/Stop] key. (Each time you press the [Cancel/Stop] button, the alarm light and power light flash alternately.)

3. When the power indicator light turns green, the printer is ready for maintenance mode operation.

Tips before operation:

1. Make sure that the driver of the printer to be cleared has been installed, and the power cord and data cable of the printer have been connected.

2. Only connect 1 printer when clearing.

3. The [Cancel/Stop] key and the [Resume/Cancel key] mentioned when the printer enters the maintenance mode are the same key, and the [ON] key and the [Power Switch] key are the same key.

Step 2: After implementing the first step, you can open the clearing software. Double-click the clearing software icon to open the software. Then select the port. Here is a special reminder. If your computer is connected to more than two printers, it is recommended that you unplug the other printer data cables before clearing the waste ink. In this way, the software will automatically connect to the only port, and you No need to worry about choosing a port.

Step 3

As shown below, click on the two buttons circled in the software

1. When you click the reset software button, the reset software becomes dim and inactive while the selected function is running.

2. When the operation is completed, the prompt "This function has been completed" will be displayed. (The software prompts in English that this function has been completed)

3. If the printer does not enter maintenance mode, the software will display "Error!" or the software will be dim and inactive.

(If the printer does not enter maintenance mode, please follow the above steps to enter maintenance mode a few times before entering.)

Step 4: After the reset is successful, restart your printer and the reset is complete.

(If the reset is not successful, please follow the steps again)

The above is the clearing method of Canon mp288 clearing software shared by the editor. Friends in need can take a look.