What should I do if I encounter a problem that cannot be recognized when using TransMac to create a mac installation disk? Some friends may not be sure yet, so today I will share with you the solution to the problem that the mac installation disk produced by TransMac cannot be recognized. Friends who need it can come and take a look. I hope it can help everyone.

First, start the PE system on the computer and insert the USB flash drive.

We opened the disk management of the PE system, checked the disk, and found that the U disk was not initialized.

At this time we open the partition tool and enter the partition tool page.

Now delete the partition of the disk.

Then we click the Format button after clicking the Save button.

Reformat the U disk once, remove the transmac and make the U disk partition, and it will be fine.

The above is the solution shared by the editor to solve the problem that the Mac installation disk created by TransMac cannot be recognized. Friends who are not familiar with it can learn it.