Nowadays, many office partners do not know how to install the software SolidWorks2019. For this reason, the editor here provides the installation steps of SolidWorks2019, hoping to help friends in need.

Download the SolidWorks2019 software compressed package file and copy the patch folder _SolidSQUAD_ to the C drive directory.

Run SolidWorks_Flexnet_Server server_install.bat" and wait until the new service will automatically install and start "SolidWorks Flexnet Server"

Download the installation package of SolidWorks2019, unzip it, or double-click to open it directly, or open it with a virtual CD-ROM drive, as shown in the figure:

Click "setup.exe" to enter the installation interface.

The following interface will pop up, click OK here.

After clicking OK, enter the following interface, click "Click to install" on this computer, and then click Next

System and check warnings, just click Next here.

After the next step is the summary interface. Click "Change" here to change the product, installation location, and toolbox special-shaped hole wizard selection content. You can set it according to your needs. It is generally recommended to choose the installation location on the D drive. Do not use C. plate.

Select "I accept the SolidWorks Terms" and click "Install Now".

Enter the installation interface, as shown in the figure:

Then the installation time ranges from about 30 minutes to 1 hour. After the installation is completed, the following interface pops up:

At this point, SolidWorks2019 is installed.

The above has explained the installation steps of SolidWorks 2019. I hope friends in need can learn it.