Many netizens report that they cannot automatically mount the specified drive letter and directory when DosBox starts. So how do they automatically mount the specified drive letter and directory when DosBox starts? Here the author provides detailed steps for automatically mounting and setting the drive letter and directory when DosBox is started. Friends in need should not miss it.

Open DOSBox and go to this directory

Open the dosbox-0.74.conf file with Notepad

Generally, if you pull the file to the bottom, you will see

[autoexec]

# Lines in this section will be run at startup.

# You can put your MOUNT lines here.

these contents

Enter in the following line: mount C E:/ASM-DEBUG (note that the following directory is the directory you want to specify), save, and close Notepad.

Open the DOSBox software again and you will see the page as shown in the figure

This is successful. Enter C: and press Enter to simulate the directory you specified later (that is, successful mounting)

The above is the detailed steps that the editor explains to you about automatically mounting and setting the drive letter and directory when DosBox is started. Let’s learn together. I believe it can help some new users.