Don’t know how to set shortcut keys when operating UG10.0? This article introduces the operation content of setting shortcut keys in UG10.0. Friends who want to learn can read the following. I believe it will be helpful to everyone.

Open UG10.0

Press the shortcut key: Ctrl+1 to display the customized menu bar

Select the keyboard in the lower right corner and the following screenshot will appear.

Select the command you need to set the shortcut key for, as shown in the figure, it is the move surface command in synchronous modeling

In Press New Shortcut Key, enter the shortcut you set (numbers or letters are acceptable)

Click Assign and your shortcut will appear in the blank column on the left

Click Close, exit to the modeling interface, press M on the keyboard, and the toolbar for moving the surface will appear.

Use the mouse to click the triangle next to the moving surface icon, and the set shortcut will appear behind the customized command icon.

The above explains the method of setting shortcut keys in UG10.0. I hope friends in need can learn it.