There must be some friends who don't know how to install the multisim14.0 software. Today, the editor will specifically explain the installation steps of multisim14.0. Friends in need should take a look!

1. Download the Multisim14.0 version software package, select the downloaded software compressed package, right-click the mouse and select unzip to "Mulitisim14.0(E)".

2. Find NI-Circuit-Design_Suite_14_0.exe in the decompressed folder, right-click the mouse and select Open.

3. Click OK.

4. Click Unzip to decompress.

5. Click OK.

6. Click the Install NI Circuit Design Suite 14.0 item.

7. Fill in the name as you like and click Next.

8. Click No.

9. Click Next.

10. Click Browse to change the installation path. It is recommended to install to a disk other than C drive. You can create a multisim14.0 folder on D drive or other drives. Then click Next.

11. Click Next.

12. Click Next.

13. Select the I accept the above 2License Adreemnrt option and click Next.

14. Click Next.

15. The software is being installed (it will take about 10 minutes).

16. Click Next.

17. Click Restart Later.

18. Find the NI license Activator 1.2.exe file in the extracted folder, right-click the mouse and select Run as administrator.

19. Find the Base item, right-click to find Activate and click OK.

20. Find the Full Edition item, right-click to find Activate and click OK.

21. Find the Power Pro Edition item, right-click to find Activate and click OK.

22. Find the Full Edition item, right-click to find Activate and click OK.

23. Find the Power Pro Edition item, right-click to find Activate and click OK.

24. Click on the Start menu bar and find NI Ultiboard 14.0 to open.

25. The installation is completed.

The above is the multisim14.0 installation method shared by the editor. Let’s learn together. I believe it can help some new users.