At present, many people use it to draw, and the operation is very convenient. So if you need to use the automatic capture function, how should you start? Next, please see the graphic tutorial for turning on Rhino’s automatic capture function. Don’t miss it if you need it.

For example, to draw a straight line, draw it again by placing one of the endpoints on the existing straight line.

When the mouse moves to one of the endpoints of the straight line, snapping is not performed automatically.

Under the software, check the endpoint.

Tip: The endpoint is the end of the line segment. If it is a straight line, there can only be two endpoints. It is very convenient to select the endpoint for automatic capture. Therefore, the main consideration is the choice of automatic capture method. You must learn what type of automatic capture method to use under what circumstances.

After checking the endpoint, move the mouse to the endpoint of the current straight line to realize automatic snapping.

Simply draw the straight line again by automatically snapping the endpoints.

If you need to automatically capture the center point of an existing circle, uncheck all other automatic capture methods and check only the center point.

Draw a straight line at the center point to coincide with the edge of the circle, cancel the automatic snapping of the center point, and change it to the nearest point.

Come and learn the graphic tutorial on how to enable the automatic capture function in Rhino. It will definitely help everyone.