At present, many novices express the operation of CDR to make flat mobile phone models. Next, the editor will share with you the operation steps of CDR to make flat mobile phone models. It is not very difficult. Let’s learn to make it together!

First draw a rectangle with a width of 8 cm and a height of 150 cm. Use the shape tool to create a 20-inch rounded corner on each side of the rectangle.

At this time, we need to make the rounded rectangle three-dimensional and fill it with white.

Draw an 80% black rectangle inside the rounded square, 6 cm wide and 11 cm high, centered on the rounded square.

Use the shadow command to give the rounded cuboid a shadow part from top to bottom to increase the three-dimensional feel of the mobile phone model.

Next, start drawing some function keys on the mobile phone. First, draw the connection of the mobile phone with two 80% black rectangles.

Finally, draw the buttons on the mobile phone model, such as camera, speaker, on/off, volume and volume buttons, etc. The finished graphic is as shown in the figure below.

Dear friends, after reading the above exciting content, you all know the detailed steps of making a flat mobile phone model with CDR!