When you encounter a black screen on your computer and cannot enter the system, and it prompts ""DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER"", don't panic! The editor below will introduce to you how to deal with the DISK BOOT FAILURE prompt when the computer starts up.

Fastest solution

1. DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER literally translates to: disk startup failed, insert the system disk, and then press the Enter key. Generally speaking, the system disk fails to boot, or the hard disk data cable interface is loose.

2. The fastest solution: Press F8 directly after booting to enter the safe mode interface.

3. Select the option "Last Known Good Configuration" to start the system. Press the Enter key to restart the computer system. Wait a moment and the system will be successfully entered! This operation is very simple and easy to use. This is how I solved this problem on my computer. If your computer still can't solve it, please see the breakdown below.

Disassemble the case and reconnect the hard drive data cable interface.

1. If the above method still cannot solve the problem, then first disassemble the chassis, rearrange the hard disk data cable and data cable interface, pull out the data cable first, clean the dust and then plug it in.

2. If it is a laptop, unscrew the screws directly and insert and remove the hard drive. Then boot into the bios interface, or press the pause break key to stop the screen when booting up, and see if the hard disk is displayed.

3. If you can see on the bios interface that the hard disk has been connected, but if you still cannot enter the system, it means that the system has failed to boot the hard disk. 1. Get a system disk and repair the system boot. 2. If you still cannot boot into the system, then you have to reinstall the system.

The above is an introduction to the solution to the DISK BOOT FAILURE when the computer is turned on. Through the introduction of this article, you must already know the meaning of this paragraph in English. After using the computer for a long time, it needs to be regularly dismantled and cleaned of dust, and system backup and restoration should be done to avoid system failure. It failed again.